Alpine iXA-W407 Owners Manual - Page 69
Foot Brake Lead / Parking Brake Lead Connection, Connection Diagram of SPST Switch Sold Separately - harnesses
View all Alpine iXA-W407 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Foot Brake Lead / Parking Brake Lead Connection iXA-W407 FOOT BRAKE (Yellow/Black) Pinch Connector (sold separately) PARKING BRAKE (Yellow/Blue) Pinch Connector (sold separately) Foot brake lamp Foot brake lead Parking brake lamp Parking brake lead Foot brake switch Chassis Battery Parking brake switch Connection Diagram of SPST Switch (Sold Separately) (If the ACC power supply is not available) iXA-W407 IGNITION (Red) BATTERY (Yellow) SPST SW (Optional) FUSE (5A) (Optional) FUSE (20A) (Optional) Battery • If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately). • The diagram and the fuse amperage shown above are in the case when iXA-W407 is used individually. • If the switched power (ignition) lead of the iXA-W407 is connected directly to the positive (+) post of the vehicle's battery, the iXA-W407 draws some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged. To prevent external noise from entering the audio system. • Locate the unit and route the leads at least 10 cm away from the car harness. • Keep the battery power leads as far away from other leads as possible. • Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis. • If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information. • Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information. 67-EN