Amana NTW4516FW Use & Care Guide - Page 5

Rinse, Final Spin, Cycle Complete, Lid Locked

Page 5 highlights

RINSE Certain cycles use a spray rinse, which adds water to the tub while the basket spins. You may hear the motor turning on briefly (short hum) to move the basket while filling. FINAL SPIN The washer spins the load at increasing speeds for proper water removal, based on the selected cycle. CYCLE COMPLETE Once the cycle is complete, this light will come on. Remove the load promptly for best results. LID LOCKED The Lock feature allows for higher spin speeds. When the Lid Locked light is lit, the lid is locked and cannot be opened without pausing the cycle. When the light is off, the lid can be opened. To open the lid after it has been locked, press START/STOP/PAUSE/ UNLOCK LID. The lid will unlock once the washer movement has stopped. This may take several minutes if the load was spinning at high speed. Press START/STOP/PAUSE/UNLOCK LID again to resume the cycle. Appearance may vary. Appearance may vary. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

5
RINSE
Certain cycles use a spray rinse, which adds water to
the tub while the basket spins. You may hear the motor
turning on briefly (short hum) to move the basket while
filling.
FINAL SPIN
The washer spins the load at increasing speeds for
proper water removal, based on the selected cycle.
CYCLE COMPLETE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
LID LOCKED
The Lock feature allows for higher spin
speeds. When the Lid Locked light is
lit, the lid is locked and cannot be
opened without pausing the cycle.
When the light is off, the lid can be
opened.
To open the lid after it has been
locked, press START/STOP/PAUSE/
UNLOCK LID. The lid will unlock once
the washer movement has stopped.
This may take several minutes if the
load was spinning at high speed.
Press START/STOP/PAUSE/UNLOCK
LID again to resume the cycle.
Appearance
may vary.
Appearance
may vary.