Ariens Hydro Pro Track 32 Owners Manual - Page 27

Clean Battery 926514, Terminals, Replace Fuse 926514, IMPORTANT, WARNING

Get Ariens Hydro Pro Track 32 PDF manuals and user guides View all Ariens Hydro Pro Track 32 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

Clean Battery (926514) WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. IMPORTANT: Battery is maintenance-free. Do not tamper with or attempt to open battery. See SERVICE AND ADJUSTMENTS on page 28 for charging procedures. Terminals Keep battery and its terminals clean. IMPORTANT: Remove battery from unit before cleaning. Remove corrosion from battery terminals and cable connections with wire brush, then wash with a weak baking soda solution. After cleaning, apply a thin coat of grease or petroleum jelly to terminals and cable ends to retard corrosion. Replace Fuse (926514) 1. Remove the two screws and the cover plate from beneath the battery. 2. Locate the fuse holder on the wiring harness and remove the fuse. 3. Install a new fuse of the same amprating and type. OS7455 Fuse and fuse holder. Figure 20 4. Replace the cover plate and secure in position with the two screws removed in step 1. NOTE: Make sure the wire harness does not get pinched between the cover plate and the auger housing. Cover plate and mounting screws. Figure 19 OS7450 EN - 27

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
EN - 27
Clean Battery (926514)
IMPORTANT:
Battery is maintenance-free.
Do not tamper with or attempt to open battery.
See
SERVICE AND ADJUSTMENTS
on
page 28 for charging procedures.
Terminals
Keep battery and its terminals clean.
IMPORTANT:
Remove battery from unit
before cleaning.
Remove corrosion from battery terminals and
cable connections with wire brush, then wash
with a weak baking soda solution.
After cleaning, apply a thin coat of grease or
petroleum jelly to terminals and cable ends to
retard corrosion.
Replace Fuse (926514)
1. Remove the two screws and the cover
plate from beneath the battery.
2. Locate the fuse holder on the wiring
harness and remove the fuse.
3. Install a new fuse of the same amp-
rating and type.
4. Replace the cover plate and secure in
position with the two screws removed in
step 1.
NOTE:
Make sure the wire harness does not
get pinched between the cover plate and the
auger housing.
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
Figure 19
OS7450
Cover plate and
mounting screws.
Figure 20
Fuse and fuse holder.
OS7455