Ariens Hydro Pro Track 32 Owners Manual - Page 34
Track Tension Adjustment, Height Adjuster Cable, Adjustment, Battery 926514, Charging
View all Ariens Hydro Pro Track 32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
5. Replace attachment drive belts (see Install new attachment drive belts on page 32). TRACK TENSION ADJUSTMENT (926325, 514) (Figure 32 and 33) Check the track tension by applying pressure on the track midway between the upper and rear track rollers. Deflection should be approximately 9,6 mm (Figure 32). If deflection is excessive, tighten the track tension. 9,6 mm HEIGHT ADJUSTER CABLE ADJUSTMENT (926325, 514) (Figure 36): 1. Make sure that height adjustment lock finger is fully engaged. 2. Loosen jam nut on cable adjustment barrel. 3. Turn the adjustment barrel to remove all cable slack and bring the overtravel arm until it makes slight contact with the right end of the slot in the height adjuster lock finger. 4. Tighten the jam nuts. Pin on overtravel arm makes slight contact 2 with end of slot. 3 Figure 34 OS7226 If unit pulls to the left or right when a straight path is desired adjust the track tension. If the unit is pulling to the left, tighten the left track adjuster. If the unit is pulling to the right, tighten the right track adjuster. To adjust (Figure 33): 1. Tighten the adjuster nut to tighten the track tension. Loosen the adjuster nut to reduce track tension. 2. Check that unit tracks straight with no pulling to either side. 1 4 Before adjusting ensure that height adjuster lock finger is fully engaged. 1. Height Adjuster Lock Finger 2. Overtravel Arm 3. Height Adjuster Cable 4. Jam Nuts Figure 36 OS7229 Track Adjusters Figure 35 OS7228 BATTERY (926514) Charging 1. Place unit on a level surface and shut off engine. 2. Disconnect negative (-) cable first, then positive (+) cable. 3. Loosen wing nut and remove battery. Place battery on bench or other wellventilated place. 4. Connect positive (+) lead of charger to positive (+) terminal and negative (-) lead to negative (-) terminal. 5. Charge the battery at two and a half amps for 10 hours. 6. Reinstall battery into unit and connect positive (+) cable first, then negative (-) cable. EN - 34