Ariens Hydro Pro Track 32 Owners Manual - Page 35

Storage, Service Parts, Accessories, Short Term, Long Term, Fuel System

Page 35 highlights

Replacing Use U1R or U1L; 240 CCA minimum @ 18°C type batteries. STORAGE WARNING: AVOID INJURY. Read and understand the entire Safety section before proceeding. SHORT TERM IMPORTANT: NEVER spray unit with high pressure water or store unit outdoors. Run with attachment clutch engaged a few minutes after each use to free unit of any loose or melting snow. Close fuel shut-off valve. Inspect unit for visible signs of wear, breakage or damage. Keep all nuts, bolts and screws properly tightened and know unit is in safe working condition. Store unit in a cool, dry protected area. LONG TERM Clean unit thoroughly with mild soap and low pressure water and lubricate (see MAINTENANCE on page 24). Touch up all scratched painted surfaces. Remove weight from wheels by putting blocks under frame or axle. FUEL SYSTEM Gasoline left in the fuel system for extended periods without a stabilizer will deteriorate, resulting in gum deposits in the system. These deposits can damage the carburetor and the fuel hoses, filter and tank. Prevent deposits from forming in the fuel system during storage by adding a quality fuel stabilizer to the fuel. Follow the recommended mix ratio found on the fuel stabilizer container. IMPORTANT: NEVER store the engine with fuel in the fuel tank inside of a building with potential sources of ignition. Add Fuel Stabilizer 1. Turn the fuel valve off while engine is running and allow the engine to run until it stops. Turn engine OFF when it begins surging to avoid engine damage. 2. Add fuel stabilizer, following the manufacturer's instructions. 3. Turn fuel valve on after adding fuel stabilizer. 4. Re-start engine. 5. Run the engine outdoors for 5 minutes to be sure that treated gasoline has replaced the untreated gasoline in the carburetor. 6. Slow the engine to an idle speed. 7. Stop engine. SERVICE PARTS Order the following parts through your Dealer: Part No. Description 00036800 Ariens Hi-Temp Grease (3x 88.72 mL cartridges) 00592900 Fuel Stabilizer (118.3 mL) 21531100 Spark Plug 07200608 Impeller Belt (Set of 2) 07200631 Traction Belt (926326, 328, 329) 07200630 Traction Belt (926325, 514) 52100100 Shear Bolt Kit 06400920 Gear Case Seal Washer ACCESSORIES See your authorized Ariens dealer to add the additional accessories available to your Sno-Thro. Part No. Description 72406500 Front Weight Kit 72406900 Slicer Bar 72600300 Composite Skid Shoes 72601500 Cover 72408000 Snow Cab EN - 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

EN - 35
Replacing
Use U1R or U1L; 240 CCA minimum @ 18°C
type batteries.
SHORT TERM
IMPORTANT:
NEVER spray unit with high
pressure water or store unit outdoors.
Run with attachment clutch engaged a few
minutes after each use to free unit of any
loose or melting snow.
Close fuel shut-off valve.
Inspect unit for visible signs of wear,
breakage or damage.
Keep all nuts, bolts and screws properly
tightened and know unit is in safe working
condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low
pressure water and lubricate (see
MAINTENANCE
on page 24). Touch up all
scratched painted surfaces.
Remove weight from wheels by putting
blocks under frame or axle.
FUEL SYSTEM
Gasoline left in the fuel system for extended
periods without a stabilizer will deteriorate,
resulting in gum deposits in the system.
These deposits can damage the carburetor
and the fuel hoses, filter and tank. Prevent
deposits from forming in the fuel system
during storage by adding a quality fuel
stabilizer to the fuel. Follow the
recommended mix ratio found on the fuel
stabilizer container.
IMPORTANT:
NEVER store the engine with
fuel in the fuel tank inside of a building with
potential sources of ignition.
Add Fuel Stabilizer
1. Turn the fuel valve off while engine is
running and allow the engine to run until
it stops. Turn engine OFF when it begins
surging to avoid engine damage.
2. Add fuel stabilizer, following the
manufacturer’s instructions.
3. Turn fuel valve on after adding fuel
stabilizer.
4. Re-start engine.
5. Run the engine outdoors for 5 minutes to
be sure that treated gasoline has
replaced the untreated gasoline in the
carburetor.
6. Slow the engine to an idle speed.
7. Stop engine.
STORAGE
WARNING:
AVOID INJURY. Read
and understand the entire
Safety
section before proceeding.
SERVICE PARTS
Order the following parts through your
Dealer:
Part No.
Description
00036800
Ariens Hi-Temp Grease
(3x 88.72 mL cartridges)
00592900
Fuel Stabilizer (118.3 mL)
21531100
Spark Plug
07200608
Impeller Belt (Set of 2)
07200631
Traction Belt (926326, 328,
329)
07200630
Traction Belt (926325, 514)
52100100
Shear Bolt Kit
06400920
Gear Case Seal Washer
ACCESSORIES
See your authorized Ariens dealer to add
the additional accessories available to your
Sno-Thro.
Part No.
Description
72406500
Front Weight Kit
72406900
Slicer Bar
72600300
Composite Skid Shoes
72601500 Cover
72408000
Snow Cab