Ariens Hydro Pro Track 32 Owners Manual - Page 31

1 2 3 OS7185 OS7191 1. Attachment Clutch Cable 2. Adjustment Barrel 3. Jam Nut Figure 27 5. With the attachment clutch disengaged, check that the attachment idler arm lightly touches the frame (Figure 26). 6. Tighten jam nut on the adjustment barrel. \ With the attachment clutch disengaged, check the attachment idler arm position here. The attachment idler arm should lightly touch the frame. Check Attachment Idler Arm Roller Clearance (Figure 27) NOTE: It will be difficult to check the measurement inside the frame. Use a 12,7 mm minimum spacer as a gauge to check the clearance between the roller and the frame. 1. Place the unit into the service position. Remove the bottom cover. 2. With the clutch lever engaged, check the clearance between the frame and plastic roller on the lower end of the attachment idler arm (Figure 27). • If roller is 12,7 - 22,2 mm from frame, no further adjustments are required. • If roller is less than 12,7 mm from frame, loosen idler adjustment nut and move idler closer to the belt. Tighten adjustment nut and recheck the roller clearance. • If roller is more than 22,2 mm from frame, loosen idler adjustment nut and move idler away from the belt. Tighten adjustment nut and recheck roller clearance. Some components removed for clarity of illustration. 4 1 Figure 28 2 3 OS7196 Roller should be 12,7 - 22,2 mm from the frame when the attachment clutch is engaged. 1. Idler Adjustment Nut 2. Attachment Idler Arm 3. Roller 4. Frame Figure 29 OS7189 EN - 31