Asus AT5IONT-I AT5IONT-I User's manual - Page 19
Internal connectors - psu
View all Asus AT5IONT-I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
GND RSATA_RXN1 RSATA_RXP1 GND RSATA_TXN1 RSATA_TXP1 GND 1.7.2 Internal connectors 1. Serial ATA connectors (7-pin SATA1, SATA2) These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk drives and optical disk drives. The Serial ATA 3Gb/s is backward compatible with the Serial ATA 1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the standard parallel ATA (133 MB/s). SATA1 SATA2 AT5IONT-I DELUXE AT5IONT-I DELUXE SATA connectors • Install the Windows® XP Service Pack 2 or later versions before using Serial ATA. 2. ATX power connector (24-pin EATXPWR) (for AT5IONT-I only) This connector is for an ATX power supply. The plug from the power supply is designed to fit this connector in only one orientation. Find the proper orientation and push down firmly until the connector completely fits. GND RSATA_TXP2 RSATA_TXN2 GND RSATA_RXP2 RSATA_RXN2 GND AT5IONT-I AT5IONT-I ATX power connector • For a fully configured system, we recommend that you use a power supply unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum power of 90 W. • We recommend that you use a PSU with higher power output when configuring a system with more power-consuming devices. The system may become unstable or may not boot up if the power is inadequate. • If you are uncertain about the minimum power supply requirement for your system, refer to the Recommended Power Supply Wattage Calculator at http://support.asus. com/PowerSupplyCalculator/PSCalculator.aspx?SLanguage=en-us for details. ASUS AT5IONT-I Series 1-10