Asus P2B-LS P2B-LS User Manual - Page 33
Chassis/CPU/Power Supply Fan Connectors 3-pin FAN
View all Asus P2B-LS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
III. INSTALLATION 21. Chassis Open Alarm Lead (4-1 pin CHASSIS) This lead can be used as an open chassis monitor. A high level signal to the CHASSIS lead will indicate to the system that the chassis has been opened. This function is available with the hardware monitor installed. III. INSTALLATION Connectors R R CHASSIS +5VSB CHASSIS GND P2B-L/S/LS Chassis Open Alarm Lead 22. Chassis/CPU/Power Supply Fan Connectors (3-pin FAN) These connectors support cooling fans of 500mA (6W) or less. Orientate the fans so that the heat sink fins allow airflow to go across the onboard heat sink(s) instead of the expansion slots. Depending on the fan manufacturer, the wiring and plug may be different. The red wire should be positive, while the black should be ground. Connect the fan's plug to the board taking into consideration the polarity of the this connector. NOTE: The "Rotation" signal is to be used only with a specially designed fan with rotation signal. WARNING! The CPU and/or motherboard will overheat if there is no airflow across the CPU and onboard heatsinks. Damage may occur to the motherboard and/or the CPU fan if these pins are incorrectly used. These are not jumpers, do not place jumper caps over these pins. Power Supply Fan Power CPU Fan Power Chassis Fan Power Rotation +12V Ground P2B-L/S/LS 12Volt Cooling Fan Power ASUS P2B-L/P2B-S/P2B-LS User's Manual 33