Asus P5Q SE R User Manual - Page 54
Chassis intrusion connector 4-1 pin CHASSIS, Front panel audio connector 10-1 pin AAFP
View all Asus P5Q SE R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
10. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS P5Q SE/R +5VSB_MB Chassis Signal GND (Default) P5Q SE/R Intrusion Connector 11. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. AAFP HD-audio-compliant pin definition Legacy AC'97 compliant definition GND PRESENSE# SENSE1_RETUR SENSE2_RETUR AGND NC NC NC P5Q SE/R MIC2 MICPWR Line out_R NC Line out_L PORT1L PORT1R PORT2R SEBSE_SEND PORT2L P5Q SE/R Front Panel Audio Connector • We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard's high-definition audio capability. • If you want to connect a high-definition front panel audio module to this connector, set the Front Panel Type item in the BIOS setup to [HD Audio]; if you want to connect an AC'97 front panel audio module to this connector, set the item to [AC'97]. By default, this connector is set to [HD Audio]. See section 4.5.4 Onboard Devices Configuration for details. 2-30 Chapter 2: Hardware information