Asus P8H61-M2 TPM SI User Manual - Page 27

P8H61-M2/TPM/SI Chassis intrusion connector

Get Asus P8H61-M2 TPM SI PDF manuals and user guides View all Asus P8H61-M2 TPM SI manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

10. Digital audio connector (4-1 pin SPDIF_OUT) This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port. +5V SPDIFOUT GND P8H61-M2/TPM/SI SPDIF_OUT P8H61-M2/TPM/SI Digital audio connector The S/PDIF module is purchased separately. 11. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS P8H61-M2/TPM/SI GND Chassis Signal +5VSB_MB P8H61-M2/TPM/SI Chassis intrusion connector Chapter 1: Product introduction 1-15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
1-15
Chapter 1: Product introduction
10.
Digital audio connector (4-1 pin SPDIF_OUT)
This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port.
SPDIF_OUT
+5V
SPDIFOUT
GND
P8H61-M2/TPM/SI
P8H61-M2/TPM/SI Digital audio connector
The S/PDIF module is purchased separately.
11.
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
P8H61-M2/TPM/SI
P8H61-M2/TPM/SI Chassis intrusion connector
GND
Chassis Signal
+5VSB_MB
CHASSIS