Asus V3-P5945GC User Manual - Page 63
Front Panel Audio Connector, Intrusion Connector
UPC - 610839942145
View all Asus V3-P5945GC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
R R 11. Front panel audio connector (10-1 pin AAFP) This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC'97 audio standard. Azalia-compliant pin definition Legacy AC'9-compliant pin definition AGND PRESENSE# MIC2_JD HP_HD AGND NC NC NC AAFP MIC2_L MIC2_R Line out_R NC Line out_L MIC2_L MIC2_R HP_R Jack_Sense HP_L Front Panel Audio Connector • We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard's highdefinition audio capability. • By default, this connector is set to AC97 Audio. If you want to connect a High Definition front panel audio module to this connector, set the Front Panel Support Type item in the BIOS to [HD Audio]. See section "2.4.5 Onboard Device Configuration" for details. 12. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. Intrusion Connector CHASSIS GND Chassis Signal (Default) +5VSB_MB ASUS V-Series P5945GC 4-11