BenQ PB9200 User Manual - Page 20
Power ON/OFF
UPC - 840046007669
View all BenQ PB9200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
PB9200-e.book Page 14 Thursday, May 27, 2004 2:15 PM Power ON/OFF WARNING • When the power is ON, a strong light is emitted. Do not look into the lens or vents of the projector. NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices. Turning On The Power 1. Remove the lens cap. 2. Set the power switch to [ | ] (ON). The STANDBY/ON STANDBY/ON button / indicator STANDBY/ON indicator will light to solid orange. 3. Press the STANDBY/ON button. The projector lamp will light up and the LENS SHIFT COMPONENTBNG S-VIDEO RGB M1-D INPUT INTER KEYSTONE SEARCH RESET VIDEO STANDBY/ON MENU TEMP LAMP FOCUS ZOOM AUDIO IN1 REMOTE CONTROL CONTROL NETWORK AUDIO IN2 RGB RGB OUT R/CR/PR G/Y B/CB/PB H V AUDIO OUT CR/PR Ca/Pa Y BNC R-AUDIO IN-L VIDEO S-VIDEO LASER INDICATOR STANDBY/ON VIDEO RGB ++ LENS SHIFT FOCUS -- + ZOOM - BLANK ASPECT LASER STANDBY/ON indicator will begin blinking green. When the power is completely on, the indicator will stop STANDBY/ON STANDBY/ ON button blinking and light green. 4. Use the LENS SHIFT buttons to shift Power switch (ON position) the picture upward or downward. LENS SHIFT 5. Select an input signal according to the section "Selecting An Input Signal" of the following page. LASER INDICATOR STANDBY/ON VIDEO RGB ++ LENS SHIFT FOCUS -- + ZOOM - BLANK ASPECT LASER LENS SHIFT buttons LENS SHIFT COMPONENTBNG S-VIDEO RGB M1-D INPUT INTER KEYSTONE SEARCH RESET VIDEO STANDBY/ON MENU TEMP LAMP FOCUS ZOOM AUDIO IN1 REMOTE CONTROL CONTROL NETWORK AUDIO IN2 RGB RGB OUT R/CR/PR G/Y B/CB/PB H V AUDIO OUT CR/PR Ca/Pa Y BNC R-AUDIO IN-L VIDEO S-VIDEO Turning Off The Power 1. Press the STANDBY/ON button. The STANDBY/ON message "Power off?" will appear on the STANDBY/ON button / indicator screen for approximately 5 seconds. Attach the lens cap. 2. Press the STANDBY/ON button again while "Power off?" the message is visible. The projector lamp will go off, and LENS SHIFT COMPONENTBNG S-VIDEO RGB M1-D INPUT INTER KEYSTONE SEARCH RESET VIDEO STANDBY/ON MENU TEMP LAMP FOCUS ZOOM AUDIO IN1 REMOTE CONTROL CONTROL NETWORK AUDIO IN2 RGB RGB OUT R/CR/PR G/Y B/CB/PB H V AUDIO OUT CR/PR Ca/Pa Y BNC R-AUDIO IN-L VIDEO S-VIDEO LASER INDICATOR STANDBY/ON VIDEO RGB ++ LENS SHIFT FOCUS -- + ZOOM - BLANK ASPECT LASER the STANDBY/ON indicator will begin blanking orange. Then the STANDBY/ ON indicator will stop blinking and STANDBY/ON STANDBY/ ON button light to solid orange when the lamp Power switch (OFF position) cooling is complete. 3. Switch the power switch to [O] (OFF). The STANDBY/ON indicator will go off. 4. Attached the lens cap. 14 Power ON/OFF