BenQ PB9200 User Manual - Page 31

PB9200-e.book Page 25 Thursday, May 27, 2004 2:15 PM PICTURE-2 Menu With the PICTURE-2 menu, the items shown in the table below can be performed. Perform each operation in accordance with the instructions in the table below. memo This menu cannot be selected at a M1-D signal. MENU MAIN V POSITION 20 PICTURE-1 H POSITION 142 PICTURE-2 H PHASE 31 INPUT H SIZE 1344 AUTO OVER SCAN 95 SCREEN RESET OPTION NETWORK : SELECT Item V POSITION H POSITION H PHASE H SIZE OVER SCAN RESET Description Adjust the vertical position using the 5 / 6 buttons. : Up Down memo This item can be selected only at a RGB signal. Adjust the horizontal position using the 5 / 6 buttons. : Left Right memo This item can be selected only at a RGB signal. Adjust the horizontal phase to eliminate flicker using the 5 / 6 buttons. : Right Left memo This item can be selected only at a RGB signal or a component video signal other than a COMPONENT port input of 525i/ 625i/SCART RGB. Adjust the horizontal size using the 5 / 6 buttons. : Large Small memo This item can be selected only at a RGB signal. memo When this adjustment is excessive, the picture may not be displayed correctly. In such a case, please reset the adjustment pressing the RESET button during this operation. Adjust the over-scan ratio using the 5 / 6 buttons. : Small Large memo This item can be selected only at a video signal. memo When this adjustment is too large, certain degradation may appear at the frame area of the picture. In such a case, please adjust small. Select the EXECUTE using the 5 button to reset the PICTURE-2 menu items. : EXECUTE CANCEL The items of the PICTURE-2 menu are collectively returned to the initial setting. Note that the item H PHASE is not reset. Multifunctional Settings 25