Bernina 2000 Manual - Page 6

Setting up the machine 1 0 Attaching the foot control 2000 DE: Plug the foot control into the machine socket (1) on the right side of the machine. Plug the power cord into the machine socket (2) and into the power socket (3). 2000 D: Plug foot control into machine socket (1) and then into power socket (2). O 10 The electronic foot control allows very fine adjustment from minimum to maximum sewing speed. The sewing speed can be adjusted by increasing or decreasing the pressure on the foot control. The maximum sewing speed is between 1350 and 1500 s.p.m. 2 --- Thread stand Push the support rod firmly into the socket on the back of the machine. Raise the support rod (1) fully, turning slightly until the positioning catches engage. Position the thread guide (2) on the thread stand so that it is parallel to the machine. = Setting up the machine 0 0 Thread cones/spools Cones or domestic spools in all sizes can be used on your Bernina overlocker. When sewing with cones, first place the stabilizing cones on the spool holder pins. o 0 When sewing with large industrial spools, use the stabilizing cones upside down, i.e. with the wider edge at the top. The stabilizing cones are not necessary when using household spools, but secure the spools with the spool holder caps, rounded side downwards. aaa Waste collector Clip the waste collector into the opening on the looper I cover. It catches the cut-off fabric as you sew, keeping your working area neat and tidy. Your overlocker is now ready for sewing. 11