Bernina 43 Manual - Page 10
Thread, Changing
View all Bernina 43 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
® Pass the right and left needle threads as illustrated below. Make certain to pass the thread between the two tension discs. ® Pull the thread end about 10cm (4 inches) beyond the needle eyes. (?) Place the needle threads together under the presser foot. ® Close front cover and cloth plate when the threading is finished. NOTE: To assist thread passing around tension dials, turn all four dials to the "O" setting and make sure the thread passes through the tension discs and behind the hook in each case. Then turn each knob to the desired setting numbers according to the fabrics (See Page 11). r EASY THREAD CHANGING Instructions for changing threads are given below. 1. Cut the threads near the spools. 2. Exchange the spools with new ones and tie the ends to the remaining threads, making the knots as small as possible. 3. Turn the Thread Tension Dials to the smallest number. 4. Press the Foot Control and run the machine until the upper and lower thread knots come through the looper holes. 5. Stop the needle thread knots before they pass through the eye of the needles. Cut the threads and, manually, pass them through the needle eyes. -7- 0 r 5 4 Cti)