Bernina 43 Manual - Page 2

IMPORTANT SAFETY INSTRUCTIONS When using an electrical overlock machine, basic safety precautions should always be followed including the following. Read all instructions before using this overlock machine. This overlock machine is designed for household use. DANGER-To REDUCE RISK OF ELECTRIC SHOCK An overlock machine should never be left unattended when plugged in. Always unplug this overlock machine from the electrical outlet immediately after using and before cleaning. Warning -To reduce the risk of burns, fire, electric shock or personal injury: 1. Do not allow to be used as a toy. Close attention is necessary when this overlock machine is used by or near children. 2. Use this overlock machine only for its intended use as described in this manual. Use only attachments recommended by the manufacturer as contained in this manual. 3. Never operate this overlock machine if it has a damaged cord or plug, is not working properly, has been dropped or damaged, or has been dropped into water. Return the overlock machine to the nearest authorized dealer or service center for examination, repair, electrical or mechanical adjustment. 4. Never operate the overlock machine with any air openings blocked. Keep ventilation openings of the overlock machine and foot control free from the accumulation of lint, dust, and loose fabric. 5. Never drop or insert any object into any opening. 6. Do not use outdoors. 7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered. 8. To disconnect, turn all controls to the off (0) position, then remove plug from outlet. 9. Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord. 10. Keep fingers away from all moving parts. Special care is required around the overlock machine needle. 11. Always use the proper needle plate. The wrong plate can cause the needle to break. 12. Do not use bent needles. 13. Do not pLill or push fabric while stitching. It may deflect the needle causing it to break. 14. Unplug your overlock machine when making any adjustments in the needle area, such as threading needles, changing needles, threading loopers, changing the presser foot, changing knives, changing the needle plate, and the like. 15. Always unplug your overlock machine from the electrical outlet when removing covers, lubricating, or when making any other user servicing adjustments mentioned in the instruction manual. 16. Always unplug overlock marthine before replacing the bulb. Always replace bulb with the same rated 15 watt bulb. SAVE THESE INSTRUCTIONS HELPFUL HINTS 1. Your lower looper has a special slot to place thread in for easy threading. This slot is pictured on the close up picture on Page 6 right below letter I. 2. To adjust stitch width, turn width dial up to increase width and down to decrease. 3. See Page 20 for instructions on how to make a narrow or rolled hem. 4. See Page 19 for instruction on how to change throat plate. When changing throat plate, be sure to remove LEFT needle. For instructions on removing left needle see Page 14.