Bissell ProHeat Pet Upright Carpet Cleaner 89108 User Guide - Page 10

Operation Set ReadyTools dial Set ready tools dial to floor cleaning. Power switch 1. Plug into a proper outlet and turn the power and heater switches to the ON ( I ) position. The switches are found on the back of the handle. Allow 1 minute for the built-in heater to warm-up before cleaning. The ProHeat will be fully warmed and will provide optimal performance after a minute of continuous heated cleaning. 2. The heater ready light indicates when the heater is ON ( I ). Note: The built in heater heats the cleaning solution for carpet and hard floor application only. It does not heat solution sprayed through the accessory tools. ReadyTools Dial Tip: Deep Cleaning stairs and heavy traffic areas on a regular basis can prolong carpet life. 1. Cleaning strokes 2. 1. While pressing the trigger, make one slow forward wet pass and another one back. Let the built-in heater, formula, and DirtLifter PowerBrush do the work for you. Caution: Do not overwet. Take care not to run over loose objects, edges of area rugs, or the cord. Stalling brush may result in premature belt failure. SmartTemp Light 2. Release the trigger and make one slow forward and backward pass over the same area to remove any residual dirty water, and aid in drying. Repeat cleaning passes until solution being pulled up appears clean. Continue passes without pressing the trigger until you can't see any more water being pulled up. NOTE: Both the SmartMix tank and the clean water tank must have liquid in them in order for the machine to spray. If one tank is empty the machine will not apply cleaning solution or water. 10 w w w . b i s s e l l . c o m 800.237.7691