Bosch B18ID80NRP Use & Care Manual - Page 24
odor/flavor.
View all Bosch B18ID80NRP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Fault Condensation forms on the dispenser unit. Ice cubes have an unpleasant odor/flavor. Ice maker is not producing any ice. Ice is not dispensed. The dispenser light does not function. The ice maker is not producing enough ice or the ice cubes are misshapen. Possible cause Remedial action The ice maker is switched off (see Switching off the ice maker"). The condensation heater does not function. You have to activate the condensation heater. - Switch on the ice maker. - Simultaneously hold down the LOCK OUT and the AGITATION buttons for 3 seconds. The WATER light and the ICE CUBE light flash twice. The ice maker is switch off and the condensation heater works. To reĆactivate the condensation heater: - Simultaneously hold down the LOCK OUT and the AGITATION buttons for 3 seconds. The WATER light and the ICE CUBE light flash once. Ice which is stored for a long time may Dispose of old ice cubes. Use the ice maker more absorb odors which impair their taste. frequently. The ice cube container is dirty. Empty and wash out the ice cube container. Unsealed packages in the freezer Check whether the frozen food has been packed transfer odor/flavor particles to the ice in airtight containers. cubes. Clean the inside of the appliance. See section on Odors". The ice cube container is in the false Reinsert the container and slide it backwards to the end position. position (see section Variable interior design"). The water pressure is too low. Check water pressure. The water pressure must be between 25 and 120 p.s.i. (1.72ć8.25 bar). The freezer compartment temperature Check temperature of the freezer compartment. is too high. If required, lower the temperature. A wrong water valve has been installed. SelfĆtapping valves and 3/16 inch (4.76 mm) saddle valves reduce the water pressure and may eventually block the pipe. The manufacturer is not liable for damage to property due to an incorrect installation or water connection. The agitation function in the ice cube PullĆout and empty the ice cube container. Remove the container is switch off. The filling level ice on the sensor. sensor is blocked. Two ice cubes can by chance be Open the door. attached to each other. These ice Remove all of the ice out of the ice chute. cubes, when joined together, can block the ice chute so that no further ice can be dispensed. The bulb is defective. Change the bulb (see Changing the bulb"). The water pressure is too low. The freezer compartment temperature is too low. Change the water filter. Check water pressure. The water pressure must be between 25 and 120 p.s.i. (1.72ć8.25 bar). Check temperature of the freezer compartment. If required increase the temperature. Instructions for changing the water filter can be found in the section Water filter". 24