Bosch HBL8753UC Installation Instructions - Page 12
Oven Installation
View all Bosch HBL8753UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Oven Installation NOTICE: Before installing the appliance, be sure to verify the cabinet dimensions and electrical connections. For Best Installation The oven can be difficult for two people to handle during installation. It is recommended to have three or more people available to assist with lifting the unit into place. Removal of the oven door during installation (to provide the necessary handholds and to significantly reduce the unit weight) can be cumbersome unless the detailed door removal instructions are followed carefully. Please take time to read and follow the instructions provided for an improved installation experience. Pre-Assembly of the Combination Oven Combination ovens require the oven and the microwave to be assembled prior to installing the combination unit into the wall cabinet. Parts Provided Universal connector bracket (2): in parts box on top of oven Assembly of the two Oven Units Notes ▯ Do not place the oven into the wall cabinet until after mounting the speed oven on top of the lower oven and securing it with the universal connector brackets. ▯ The universal connector brackets are interchangeable for the left and right sides of the oven. Be sure the taller vertical edge of the bracket is positioned to the outside of the oven. 1. Install both universal connector brackets on top of the lower oven using six (6) of the screws provided. Tighten screws securely, but do not overtighten. Screws (16): in red bag inside parts box on top of oven. Oven Mounting Screws (8): Screws are included to secure the oven trim to the cabinet. The screws are located in a small plastic bag affixed to the literature pack bag. Trim Piece: in plastic bag on top of oven. 12 2. Install decorative trim. Position the decorative trim piece so the flanges with the holes in them face to the rear of the oven. Align the outer flanges with the outside of the universal brackets. Fasten with one (1) screw each into the end hole of each universal bracket. Tighten screws securely, but do not overtighten.