Bosch HBL8753UC Installation Instructions - Page 16
How to Replace the Oven Door
View all Bosch HBL8753UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Proceed to lift the oven following the guidelines below with the door removed: ▯ Lift points (1) on the front of the unit are for lifting from the sides of the unit. Lift point (3) on the front of the unit is for a third person to help lift the unit. ▯ Lift point (2) on the back of the unit shows the location of the opposite hand for the helpers lifting from the sides of the unit. Adjust the location as needed to facilitate the lift. Single Oven Combination Oven 5. Install the supplied screws through the tap holes in the trim (2 screws for single ovens, 4 screws for combination ovens). It is recommended to drill pilot holes for the trim screws. To ensure the door and oven function properly, the screws should be installed on the face of the side trim 6. Replace the oven door accordingly. See "Re-Install the Oven Door". How to Replace the Oven Door 1. Holding the door firmly in both hands, grip it on either side, not by the handle. 2. Tilt the door back slightly towards you until it opens about 7 inches at the top. 3. Slide the hinges into the slots as far as they will go and then lower the door straight down. The angle of the door may need to be adjusted slightly to allow the hinges to engage properly and the door to lower into place. The door should lower about 3/4" and stop. If not, the hinges have not engaged properly and the door could fall if it is released. # " Placing Oven Into Cabinet Opening 1. The unit and its bottom packaging (pallet) should be positioned close to and in front of the cabinet opening prior to beginning to lift the unit into place. 2. Lift or slide unit into the cabinet cutout without allowing the unit base to contact the flooring. 3. Guide the unit straight back into the cabinet cutout. Push the unit straight in until the oven trim is about 2 inches from being flush with cabinet wall. Note: Be careful not to crimp the flexible conduit between the oven and the cabinet back wall. If necessary, guide the flexible conduit into the wall of cabinet access hole so it doesn't prevent the unit from being pushed all the way into the cabinet opening. The oven should be straight and level. 4. Push the unit all the way back into the cabinet cutout until the front edge of the unit is flush with the front of the cabinet. 4. Once both hinges are fully engaged as described in Step 3, gently open the door until it is fully open. 5. Push the levers on both the hinges up and forward until they are locked into the slot and flush with the front of the oven body. 6. Close and open the door slowly to be sure it is correctly and securely in place. 16