Bosch SHX4AP06UC Use and Care Manual - Page 24

Problem

Page 24 highlights

Problem Odor Dishwasher not filling with water Water Leaks Tub stains Cause 1. Food debris is present at the bottom of the dishwasher. 2. Food particles are present near the door seal. 3. Dishes left too long in unit before running a cycle. 4. Residual water is present at the bottom of the dish- washer. 5. Drain hose is obstructed. 1. Restriction in the water supply system. 2. Previous wash cycle was not completed. 3. Delay-start is active. 1. Suds 2. Door seal could be pulled away from track. 3. Condensation vent is blocked. 4. Improper installation. Action 1. Remove the filters and clean according to the "Check/Clean the Filter System" section of this manual. 2. Refer to "Clean the Door Gasket and Door Seal" in the Care and Maintenance section of this manual. 3. Run a Rinse/Hold cycle if you do not intend to immediately wash the dishes. 4. Ensure the unit has completely drained from the last cycle. Refer to the "Canceling or changing the cycle" section of this manual. 5. Remove any obstructions from the drain hose by calling qualified personnel. Note: If odor still persists, run the Normal/Regular cycle until it flushes and interrupt the cycle and place an 8 oz. cup of distilled white vinegar solution on the top rack and then finish the cycle. 1. Ensure that the water supply valve (typically located under kitchen sink) is open and check that the water supply line has no kinks and clogs. 2. Refer to the"Canceling or changing the cycle"section of this manual. 3. Cancel the delay-start or wait until delay-start time completes (times out). Refer to the "Delay Start" section of this manual. 1. Wrong type of detergent results in suds and leaks. Use only dishwasher detergents. If suds still persist, then add one tablespoon of vegetable oil atthe bottom of the dishwasher and run the desired cycle. 2. Ensure that door seal is in the track. 3. Ensure that condensation vent is not blocked. Refer to "Loading Extra Tall Items" in the Preparing and Loading the Dishwasher section of this manual. 4. Have proper installation verified by qualified personnel (water supply, drain system, leveling, plumbing). 1. Stains on the dishwasher interior are due to hard- 1. Concentrated Lemon juice can reduce the build up of hard ness of water. water stains. Run a normal cycle until it flushes and interrupt 2. Silverware in contact with tub. the cycle and then place an 8 oz. cup of the concentrated lemon solution on the top rack and finish the cycle. This can be done periodically to avoid build up. 2. Ensure that the silverware does not make contact with the tub while running a cycle. Streaks on glassware or residue on the dishes Incorrect rinse agent setting. Depending on the hardness of water, adjust the rinse agent dispenser. Refer to "Adding Detergent and Rinse Agent" section in this manual for adjustment. Fascia panel discolored or marked Noise during wash cycle Abrasive cleaner used. The dishes may not be arranged properly. Use mild detergents with soft damp cloth. Water circulation sound is normal, but if you suspect items are banging into each other or into the spray arms, refer to the "Preparing and Loading" section of this manual for optimal arrangement. Detergent dis- penser cover will not shut 1. Improper operation of detergent cover. 1. Refer to "Adding Detergent and Rinse Aid" section of this 2. Previous cycle has not been finished, reset, or cycle manual for instructions on opening and closing the dis- was interrupted. penser. 2. Refer to the "Canceling or changing the cycle" section of this manual. Unable to select desired cycle 24 Previous cycle has not finished. Refer to the "Canceling or changing the cycle" section of this manual.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80

Problem
Cause
Action
Odor
1.
Dishwasher
not
filling
with
water
Water
Leaks
Tub stains
Streaks on glass-
ware or residue
on the dishes
Fascia panel
discolored
or
marked
Noise during
wash
cycle
Detergent
dis-
penser
cover will
not shut
2.
3.
4.
24
Food
debris
is present
at the
bottom
of
the
dish-
washer.
Food particles
are present
near the
door
seal.
Dishes
left too
long in unit
before
running
a cycle.
Residual
water
is present
at the
bottom
of the dish-
washer.
5.
Drain
hose is obstructed.
1.
Remove
the
filters
and
clean
according
to the "Check/Clean
the
Filter System"
section
of this
manual.
2.
Refer to "Clean
the
Door
Gasket and
Door
Seal" in the
Care
and Maintenance
section
of this manual.
3.
Run a Rinse/Hold
cycle
if you do
not
intend
to
immediately
wash the
dishes.
4.
Ensure the
unit
has completely
drained
from
the
last
cycle.
Refer to the "Canceling
or changing
the
cycle" section
of this
manual.
5.
Remove
any
obstructions
from
the
drain
hose
by
calling
qualified
personnel.
Note:
If odor
still
persists,
run the
Normal/Regular
cycle
until
it
flushes
and
interrupt
the
cycle
and place
an 8 oz. cup of distilled
white
vinegar
solution
on the
top
rack and then
finish
the cycle.
1.
Ensure that
the
water
supply
valve (typically
located
under
kitchen
sink) is open
and check that
the water
supply
line has
no kinks and clogs.
2.
Refer to the"Canceling
or changing
the
cycle"section
of this
manual.
3.
Cancel
the
delay-start
or wait
until
delay-start
time
com-
pletes
(times
out).
Refer to
the "Delay
Start"
section
of this
manual.
1.
Restriction
in the water
supply
system.
2.
Previous
wash
cycle
was not completed.
3.
Delay-start
is active.
1.
Suds
2.
Door
seal could
be pulled
away
from track.
3.
Condensation
vent
is blocked.
4.
Improper
installation.
1.
Stains
on the
dishwasher
interior
are due
to
hard-
ness of water.
2.
Silverware
in contact
with
tub.
Incorrect
rinse agent
setting.
Abrasive
cleaner
used.
The dishes may not
be arranged
properly.
1.
Improper
operation
of detergent
cover.
2.
Previous
cycle
has not
been finished,
reset, or cycle
was interrupted.
1.
Wrong
type
of detergent
results
in suds and
leaks. Use only
dishwasher
detergents.
If suds
still
persist,
then
add
one
tablespoon
of vegetable
oil atthe
bottom
of the dishwasher
and
run the desired
cycle.
2.
Ensure that
door
seal is in the track.
3.
Ensure
that
condensation
vent
is not
blocked.
Refer
to
"Loading
Extra Tall Items"
in the
Preparing
and
Loading
the
Dishwasher
section
of this
manual.
4.
Have proper
installation
verified
by qualified
personnel
(wa-
ter supply,
drain
system,
leveling,
plumbing).
1.
Concentrated
Lemon
juice
can reduce
the
build
up of hard
water
stains. Run a normal
cycle
until
it flushes
and interrupt
the
cycle
and
then
place
an 8 oz. cup
of the
concentrated
lemon
solution
on the top
rack and finish
the
cycle. This can
be done
periodically
to avoid
build
up.
2.
Ensure
that
the
silverware
does
not
make
contact
with
the
tub
while
running
a cycle.
Depending
on the
hardness
of water,
adjust
the
rinse agent
dis-
penser.
Refer to "Adding
Detergent
and
Rinse Agent"
section
in
this
manual
for adjustment.
Use mild
detergents
with
soft damp
cloth.
Water
circulation
sound
is normal,
but
if you
suspect
items
are
banging
into each
other
or into
the
spray arms,
refer to the "Pre-
paring
and
Loading"
section
of this
manual
for optimal
arrange-
ment.
1.
Refer to
"Adding
Detergent
and
Rinse
Aid"
section
of
this
manual
for
instructions
on
opening
and
closing
the
dis-
penser.
2.
Refer to the "Canceling
or changing
the cycle" section
of
this
manual.
Unable
to select
Previous
cycle
has not finished.
Refer to the "Canceling
or changing
the cycle" section
of this
desired
cycle
manual.