Boss Audio BV9980NV User Manual - Page 9
General Settings, WIRING DIAGRAM - operation
View all Boss Audio BV9980NV manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
General Settings In the set interface click [GENERAL] icon, into the General set interface. (Password: 888888). General settings have been set at the factory. System setting In the General Settings screen, click [SYSTEM] icon to enter the System setting interface, as shown below: Language setting In the General Settings screen, click [LANGUAGE] icon to enter the Language setting interface, as shown below: You can choose the system settings interface has the feature is turned on or off. Slide up and down to select your preferred language mode. Car Set setting In the General Settings screen, click [Car Setting] icon to enter the agreement setting interface, as shown below: Regional radio In the General Settings screen, click [RADIO] icon to enter the Radio setting interface, as shown below: You will need to set protocol, click the icon to confirm the save the settings. Select your desired area. Version Information In the General Settings screen, click [VERSION] icon to enter the Version Information interface. 15 WIRING DIAGRAM This player is equipped with ISO standard connector, please follow below instruction: ● Red - ACC ON (+12V) ● Grey/Grey black - Right front speaker (+/-) ● Yellow - 12 V Constant ● White/White black - Left front speaker (+/-) ● Black - Ground wire ● Purple/Purple black - Right rear speaker (+/-) ● Blue - Power Antenna / Remote Amp Turn On ● Green/Green black - Left rear speaker (+/-) ● Violet/White-Reverse Gear Signal (+) ● Light Green-Parking Brake (-) TROUBLE SHOOTING PROBLEM CAUSE SOLUTION Check fuse Cannot power on Some factors cause MPU wrong operation Change fuse same as the old one Press RES button on the panel by penpoint, then, power on After ignition switch off, setting Change battery or fuse information all lose Reset information and save Poor performance Weak signal of radio station Cannot load disk There is a disk inside Disc is scratched Put wrong side of disc into Cannot play disc the unit Lens is dirty Move the car to another place, then research Remove disc before inserting another one Change new disc Insert in the disk with sign side up Clean lens by lens clean disc Cannot switch language/subtitle No image There is only one language/ subtitle in disc Other factors cause MPU wrong operation If disc is not with multi-language/subtitle, it cannot switch language/subtitle Press RES button on the panel by penpoint, then, power on Cannot watch image during driving Park the car in a safe place, put the car stall It's not allowed to watch image during driving in " P " postion, pull up the hand brake, parking brake wire must be grounded 16