Bowflex Revolution Assembly Manual - Page 31
Adjusting Rope Tension
View all Bowflex Revolution manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Adjusting Rope Tension 29 Pay close attention to maintenance of the rope tension. Over time and with heavy use, the ropes are designed to give slightly. Located on the main engine housing is a tension control knob which allows you to increase the tension in the ropes. Checking for incorrect cable tension is simple. 1. Position the adjustable swing arms in the upper most position. 2. Check to see if clips at end of rope hang down or if they are tight against the pulley. 3. If ropes don't have enough tension, use the tension control knob on the side of the machine to tighten the ropes. (See image). 4. To increase tension, pull tension knob outward and turn the large pulley clockwise. The clip on the rope should be touching the pulley. There are tension knobs on each side of the machine. To increase rope tension, pull knob and turn the large pulley clockwise. You'll know when you have enough tension when the rope retracts and the clip touches the pulley. The clip should stop here. Large pulley. This is what you need to turn to increase the tension on the rope. Pull the tension knob and use your other hand to turn the large pulley clockwise. In this image, the clip extends a few inches below the pulley, so there is not enough tension in the rope. The clip should be tight against the pulley with appropriate tension.