Bowflex Sport Assembly Manual - Page 18
Step 18 - Attach the Rod Box Frame to the Lat Tower, Step 19 - Attach the Faceplate to the Main, - power rods
View all Bowflex Sport manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Assembly Guide Step 18 - Attach the Rod Box Frame to the Lat Tower Locate the following items: • From Step 16 - Main Assembly • From Step 17 - Rod Box/Frame Assembly • Item #K - (2) 3/8" X 5" Button Head Screws • Item #N - (4) 3/8" Washers • Item #O - (2) 3/8" Nylock Nuts Align the bolt holes on the Rod Box brackets with the bolt holes on the Lat Tower above the Chest Bar , as shown in Figure 18. Figure 18 K N Rod Box Brackets Place (2) 3/8" Washers (Item #N) over the ends of (2) 3/8" X 5" Button Head Screws (Item #K) - one washer per screw. Insert the screws through the aligned holes. Place (1) 3/8" Washer and (1) 3/8" Nylock Nut (Item #O) over the end of each screw and tighten. Chest Bar O Completely tighten hardware installed during Step 18. Step 19 - Attach the Faceplate to the Main Assembly Locate the following items: • Item #26 - Faceplate • From Step 18 - Main Assembly • Item #A - (2) #10 Phillips Head Screws Figure 19 Faceplate "Stems" Position the textured side of the Faceplate (Item #26) against the Lower Lat Tower. Insert the plastic "stems" through the corresponding holes on the Lower Lat Tower, as shown in Figure 26 19. You may need to push the Power Rods® out of the way to insert the screws into the holes. Attach the Faceplate to the Lower Lat Tower by threading (2) A #10 Phillips Head Screws (Item #A) into the "stems". Do not completely tighten hardware installed during Step 19 tighten screws approximately 1/2 of completion. Hardware will be tightened during Step 20. 16