Brother International CP-1800 Owners Manual - English - Page 6

2. Setup Wall mounting With the enclosed wall-mounting bar, the copyboard can easily be mounted on a wall. Attaching the wall-mounting bar Follow the precautions below to mount the copyboard correctly on the wall and reduce the risk of it falling down. a + Use the enclosed anchors to attach the wall-mounting bar to plasterboard that is at least 0.5 in. to 0.63 in. (12.7 mm to 15.9 mm) thick. When mounting the copyboard on other types of walls, consult with a contractor first and be sure to use the appropriate types of screws. Make sure that there is no metal, wood, or wires behind the wall at the points where the anchors will be installed. Before mounting the copyboard on the wall, check that it is operating correctly. After loading the paper, lay the copyboard on the floor, facing upward, to check the operation. The sensor for paper doesn't work when the copyboard is laid on the floor. If the paper doesn't come out from the unit after pressing or , make sure that the paper is loaded. During installation, keep in mind that an anchor is difficult to remove once it has been installed in the wall. 1 Hold the wall-mounting bar against the wall at the position where it will be attached, making sure that it is level, and then mark the wall at the four points where the anchors will be installed. + Be sure to attach the bar using either pair of holes A or B together with either pair of holes C or D. It is recommended that holes A and D be used. However, holes B and C can be used if necessary. Wall-mounting bar 1.42 in. (36 mm) 2.36 in. (60 mm) A B A B 23.34 in. (593 mm) 2.36 in. (60 mm) C D C D 4