Brother International CP-1800 Owners Manual - English - Page 7

Position of the wall-mounting bar in relation to the copyboard, ew by turning it clockwise

Get Brother International CP-1800 PDF manuals and user guides View all Brother International CP-1800 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 7 highlights

2. Setup Position of the wall-mounting bar in relation to the copyboard 10.2 in. (259 mm) 10.2 in. (259 mm) 1.9 in. (48 mm) 36.7 in. (932 mm) 2 Using a 5/16 in. (8 mm) drill bit, drill a hole at each point marked on the wall. 3 Insert one of the enclosed anchors into each hole, and then push it into the wall until the teeth on the rim firmly grip the wall. PUSH 4 Tighten each screw (by turning it clockwise) approximately 20 turns. a The screws must be tightened by hand. Do not use an electric screwdriver, otherwise the copyboard may fall down. 5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
5
10.2 in.
(259 mm)
10.2 in.
(259 mm)
1.9 in.
(48 mm)
36.7 in.
(932 mm)
2
Using a 5/16 in. (8 mm) drill bit, drill a hole at each point marked on the
wall.
3
Insert one of the enclosed anchors into each hole, and then push it into
the wall until the teeth on the rim firmly grip the wall.
4
Tighten
each scr
ew (by turning it clockwise)
approximately 20 turns.
a
The screws must be tightened by hand.
Do not use an electric screwdriver,
otherwise the copyboard may fall down.
PUSH
Position of the wall-mounting bar in relation to the copyboard
2. Setup