Brother International DreamWeaver„ XE VM6200D Users Manual - English - Page 315

ERROR MESSAGES Marks Error Messages OK to delete the selected pattern? OK to delete the selected picture? Cause/Solution This message is displayed when, after selecting a pattern, or is pressed and the pattern is about to be deleted. This message is displayed when the image is deleted. A 2 Maintenance and Troubleshooting OK to delete the setting? This message appears when or is pressed to delete the settings for a utility stitch. To delete the selected settings, press . OK to recall and resume previous memory? This message appears if the machine is turned off while sewing, then turned on again. Press to return the machine to the condition (pattern position and number of stitches) when it was turned off. Follow the procedure described in "If the Thread Breaks During Sewing" on page E-27 to align the needle position and sew the remainder of the pattern. OK to reset the pattern's border setting, position and/or angle? This message appears when you try to use the automatic positioning function using the sensor pen with the pattern, rotated or replaced, or with the border pattern. (see page B-83) OK to revert to the original position and/or angle? This message appears when you try to use the automatic positioning function using the sensor pen with the pattern, rotated or replaced. (see page B-83) Preventive maintenance is recommended. This message is displayed when the machine needs to be maintained. (see page A-19) Raise the buttonhole lever. Remove Dual Feed module from the machine. Remove Embroidery foot with LED pointer from the machine. Retrieving the pattern. Wait a moment. This message is displayed when the buttonhole lever is down, a stitch other than a buttonhole is selected, and the "Start/Stop" button or the "Reverse Stitch" button is pushed. This message appears when you try to start embroidering with the dual feed foot attached to the machine. Remove the dual feed foot before entering the embroidery mode. (see page B-68) This message appears when you try to start sewing utility/decorative stitch or character pattern with the embroidery foot with the LED pointer attached to the machine. Remove the embroidery foot with the LED pointer before entering the sewing mode. (see page B-61) This message is displayed when the machine is retrieving a previously saved pattern while in "Embroidery Edit" mode. Sensor module error. This message appears when something is wrong with the sensor unit of the machine. Consult your authorized dealer. Set the clock. This message appears when the time/date is not set. Set time/date. (see page B-22) The bobbin thread is almost empty. This message is displayed when the bobbin thread is running out. The bobbin winder safety device has activated. Is the thread This message is displayed when the bobbin is being wound, tangled? and the motor locks because the thread is tangled, etc. The carriage of the embroidery unit will move. Keep your hands etc. away from the carriage. This message appears before embroidery unit moves. The ending point cannot be selected for this stitch. The needle position cannot be changed for this stitch. The needle will move. Keep your hands etc. away from the needle area. This message appears when the function to specify the sewing end point cannot be used with the current stitch. Select other stitch. (see page B-81) This message appears when the function to specify the needle drop position cannot be used with the current stitch. Select other stitch. (see page B-81) This message appears when you touch the point closer than 2 cm from the needle drop point with the sensor pen in the sensor function. (see page B-73) Appendix A-35