Brother International HL5050 Users Manual - English - Page 49
Basic, Paper, DL Long Edge, MP Tray, Source, Media Type, Thick Paper, sides of the tray.
UPC - 012502605645
View all Brother International HL5050 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
6 Press and slide the paper-width guide to fit the envelope size. Figure 1-39 DL size double-flap envelopes ■ If the DL size double flap envelope is creased after printing, go to the Basic tab, select Paper Size and then select DL Long Edge. Put a new DL size double-flap envelope in the MP tray with the longest edge of the envelope in first, then print again. When you put envelopes in the MP tray, please remember the following; ■ During printing, the inside tray rises to feed envelopes into the printer. ■ The side to be printed on must be face up. ■ Put the leading edge (top of the paper) in first and push it gently into the tray. ■ The top of the envelope stack must be under the maximum paper height guides that are on both sides of the tray. 7 Send the print data to the printer. 8 After you finish the print job, close the back output tray. ■ If envelopes get smudged during printing, in the printer driver select MP Tray as the Paper Source for a straight paper path. Then, set the Media Type to Thick Paper or Thicker Paper to increase the fixing temperature. To adjust the print density setting, see Chapter 3. ■ Envelope joints that are sealed by the manufacturer should be secure. ■ All sides should be properly folded without any wrinkles or creases. 1 - 32 ABOUT THIS PRINTER