Brother International Innov-is 40 Operation Manual - Page 36
Removing the walking foot
View all Brother International Innov-is 40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
GETTING READY Lower the presser foot lever, insert the presser c foot holder screw, and then tighten the screw with the screwdriver. Raise the presser foot lever. c a a a Presser foot holder screw CAUTION ● Be sure to securely tighten the screw with the screwdriver, otherwise the needle may touch the presser foot, causing it to bend or break. ● Before starting to sew, slowly turn the handwheel toward you (counterclockwise) and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break. Note ● When sewing with the walking foot, sew at a speed between slow and medium. ■ Removing the walking foot Press (needle position button) once or a twice to raise the needle. a Presser foot lever X The presser foot is raised. With a screwdriver, loosen the presser foot d holder screw, and then remove the walking foot. a a Presser foot holder screw Attach the presser foot holder. e • For details, refer to "Removing the presser foot holder" (page 32). Memo ● Only the straight stitch (with reinforcement stitching) and the zigzag stitch can be used with the walking foot. For details on the stitches, refer to "Stitch settings" (page 87). ● The optional walking foot is available through your Brother dealer. a Needle position button X The needle is raised. Turn off the sewing machine. b 34