Brother International PC-210PRW Users Manual - English - Page 74
When sewing, be sure that the needle, does not touch the button, otherwise
View all Brother International PC-210PRW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
UTILITY STITCHES Place the button into button-sewing foot "M". 4 CAUTION ● When sewing, be sure that the needle does not touch the button, otherwise the needle may bend or break. CONTENTS 1 1 Button • When attaching four-hole buttons, first sew the two holes closest to you. Then, slide the button so that the needle goes into the two holes toward the rear of the sewing machine, and then sew them in the same way. Start sewing. 9 • After sewing for about 10 seconds at low speed, press (reverse/reinforcement stitch button) to sew reinforcement stitches. Pull the upper thread at the end of the 0 stitching to the wrong side of the fabric, and then tie it with the bobbin thread. Use scissors to cut the upper thread and the bobbin thread at the beginning of the stitching. GETTING READY SEWING BASICS UTILITY STITCHES Select stitch . 5 • For details, refer to "Selecting stitching" (page 54). Adjust the stitch width so that it is the same as 6 the distance between the holes in the button. Set the stitch length adjustment slider to the 7 shortest stitch length setting. Turn the balance wheel toward you to check 8 that the needle correctly goes into the two holes of the button. When you are finished attaching the button, a slide the drop feed lever to (to the left as seen from the front of the machine) to raise the feed dogs. 1 1 Back side APPENDIX INDEX 68