Brother International RH-981A Instruction Manual - Spanish - Page 82
Circuit board DIP switches
View all Brother International RH-981A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 82 highlights
11. CHANGING FUNCTIONS USING THE DIP SWICHES 11-2. Circuit board DIP switches DANGER Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before opening the face plate of the control box. Touching areas where high voltages are present can result in severe injury. The ON/OFF positions of the DIP switches inside the control box are checked only once when the power is turned on. Any changes to the DIP switch positions will not be effective until the power is switched off and back on again. Circuit board DIP switch C 2426Q No. ON/OFF Setting items Default ON Special lapel cutting device enabled 1 OFF Special lapel cutting device disabled OFF ON Button hole sensor of special lapel cutting device enabled 2 OFF Button hole sensor of special lapel cutting device disabled OFF ON With pressure sensor 3 OFF Without pressure sensor OFF ON - 4 OFF - OFF ON Upper thread nipper enabled 5 OFF Upper thread nipper disabled OFF ON Lower thread trimming enabled 6 OFF Lower thread trimming disabled ON ON - 7 OFF - OFF ON Maximum straight bar tacking length = 9.0 mm 8* OFF Maximum straight bar tacking length = 6.0 mm OFF * If the maximum straight bar tacking length is set to 9.0 mm, it will be necessary to process the work clamp plate. Consult with your local Brother sales office for further details. If the work clamp plate is not processed, the throat plate may interfere with the needle plate and work clamp plate. RH-981A 75