Brother International SB7900E Operation Manual - Page 11
Needle and embroidery foot Right-side/rear view
View all Brother International SB7900E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Needle and embroidery foot section Right-side/rear view a Thread guide disk Pass the thread through the thread guide disk when using the needle threader to thread the needle. b Needle bar thread guide Pass the upper thread through the needle bar thread guide. c Needle plate When the needle is lowered, it enters the hole in the needle plate. d Needle plate cover Remove the needle plate cover to clean the bobbin case and race. e Bobbin cover/bobbin case Remove the bobbin cover, and then insert the bobbin into the bobbin case. f Embroidery foot "Q" This presser foot is used for embroidering. a Handle Carry the machine by its handle when transporting the machine. b Handwheel Turn the handwheel toward you (counterclockwise) to raise and lower the needle. c Embroidery card slot Insert the embroidery card. d Air vent The air vent allows the air surrounding the motor to be exchanged. Do not cover the air vent while the machine is being used. e Power supply jack Insert the plug on the power supply cord into the power supply jack. f Main power switch Use the main power switch to turn the machine on and off. Memo z Refer to pages 8 through 11 while you are learning to use your machine. 9