Canon 2812B004 VB-C60 Operation Guide - Page 74

View Restriction Tool ● When changing settings for camera's installation conditions, you need to recapture Note a panorama image and register again. ● Panorama Preview may be slightly different from the actual picture. You need to check if the view restrictions are correctly reflected in VB Viewer after the view restrictions have been set. ● You should use VB Viewer when confirming the setting. (view restriction is not applied in Admin Viewer.) ● If changing the setting of Image Stabilizer after View Restriction settings, the view restriction area may be different between when it is set and when it is actually used (→ P.3-20). ● When changing Image Stabilizer or Digital Zoom setting, you need to reconfirm the view restriction. ● Even when view restriction is set, if the camera is controlled to capture near the Tip boundary of the view restrictions, the restricted area may be momentarily captured. ● To release view restriction, clear the "Apply the view restriction" check box and then click "Apply" and "Save View Restriction". ● When the value is blank while "Apply the view restriction" is checked, the maximum view restriction value is used. ● The controllable area and captured area are as follows: maximum up/down capture area Tilt controllable area Pan controllable area Maximum left/right captured area Maximum wide-angle viewing angle 2-16