Canon C50i Instruction Manual - Page 36
Selecting the Camera to be Controlled
UPC - 013803054415
View all Canon C50i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
ID Mode Selecting the Camera to be Controlled As shown in the figure below, of 4 cameras (ID1 to ID3) only the cameras with ID number 2 (2 cameras) are selected for ID mode operation. In normal operation, the camera LEDs turn green. ID1 ID2 ID2 ID3 Green Green Green Green ● Check the LEDs on all the adjacent connected cameras to ensure that all the cameras are receiving the signals from the wireless controller. NOTE ● The cameras (ID: 0) that have not been assigned on ID number are switched on in step 2. ● Even if the cameras are switched off, when you press the i button the LEDs on all the cameras blink orange and you can begin ID mode operation. However, when a number button was pressed in step 2, the cameras with ID numbers that do not match are switched off. BRIGHT ZOOM T W SET/OK HOME CANCEL AF 1 MF 4 ∞ 7 ON SCREEN Fn 23 56 89 0 ID MENU 1. Press the i button. The LEDs on all the adjacent connected cameras blink orange (at 0.5-second intervals). ID1 ID2 ID2 ID3 Blinking orange Blinking orange Blinking orange Blinking orange To cancel ID mode operation, press the c or i button. The LEDs on all the cameras then turn green. 2. Press a number button (in this case 2). The cameras with ID2 are selected and the LEDs on only those cameras turn green. The LEDs on the other cameras turn orange (not blinking). ID1 ID2 ID2 ID3 Orange Green Green Orange This completes the selection procedure. When you use the wireless controller, only the selected cameras will respond. When you press a button on the wireless controller, the LEDs on the selected cameras blink green (at 0.1-second intervals) and the LEDs on the other cameras blink orange (at 0.1-second intervals). 36