Canon Color imageCLASS MF9220Cdn imageCLASS MF9280Cdn/MF9220Cdn Basic Operatio - Page 488
Sided unit modes., This size cannot be used
View all Canon Color imageCLASS MF9220Cdn manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 488 highlights
Error Messages Message Description Action The memory is full. - The number of TX/RX jobs that can be stored in memory reached the maximum. - The maximum numbers of jobs that can be stored in memory are as follows (Based on the condition that the other party sends the fax by the Color imageCLASS MF9280Cdn/ Color imageCLASS MF9220Cdn with ITU-T No. 1 Chart standard mode): Up to 70 jobs for sending or 90 jobs for receiving, 95 fax jobs including sending and receiving, or 75 e-mail and I-fax jobs for receiving. Wait for the machine to send any documents in memory. Also print, send, or delete any documents stored in memory. The number of search results has exceeded limits. If the desired destination is not displayed, change the search conditions and try again. The number of addresses that meet the search criteria exceeds the specified maximum number of addresses to search. - Narrow down the search criteria, and then search again. - Increase the maximum number of addresses to search. (See "Network Settings," in the e-Manual.) The scan area is dirty. The feeder's scanning area is dirty. Clean the feeder's scanning area. This size cannot be used with 2-Sided unit modes. The paper size is not appropriate for Set the paper size to or , a two-sided copy. then load paper of the same size. Transmission has been suspended. Contact system manager. You tried to send e-mails or I-faxes when the machine is in the User ID Management with the e-mail address of the login user not registered. Use the Remote UI to register the e-mail address for each user when User ID Management is enabled. Turn off the main power on the right side of the machine. Description Some kind of error has occurred in the machine. Turn OFF the main power switch, wait for more than 10 seconds, then turn it ON again. If the message persists, write down the error code displayed on the bottom left side of the display, turn OFF the main power switch, disconnect the power cord, and contact Canon Customer Care Center. Wait a moment... This message appears when turning Wait until the message disappears. ON the main power switch, or when the machine is not ready for printing. Troubleshooting 12-33