Canon DS810 Photo Printing Guide - Page 84
Continue, POWER, Alarm
UPC - 013803049121
View all Canon DS810 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Troubleshooting Camera Error Message Try This Printer in use/Printer warming up • Images are being printed from the computer. Wait until printing ends. The printer automatically starts printing the images from the camera after completing the current printing. • If the printer is warming up, wait until warm-up ends. When it is ready, the printer starts printing automatically. No paper/Paper Error Load the paper in the Auto Sheet Feeder, and select Continue*1 in the display on your camera. Paper jam Select Stop in the display on your camera to stop printing. Remove the jammed paper, load new paper, and press the OK button on the printer and retry printing. Printer cover open Close the Cover on the printer. No printhead The Print Head is defective or not installed. Install a Print Head according to Easy Setup Instructions on page 3. If the Print Head has already been installed, remove the Print Head and reinstall it. If the error still remains, the Print Head may be defective. Contact the Canon service representative. Waste tank (ink absorber*2) full The printer has built-in waste ink absorber to hold the ink used during Print Head Cleaning. This error message indicates that the waste ink absorber is nearly full. You can continue printing for a while by selecting Continue*1 in the display on your camera. However, because printing is disabled once the waste ink absorber becomes completely full until the waste ink absorber is replaced, you are recommended to contact the Canon service representative as early as possible. (You will need to replace a particular part of the printer.) No Ink Install an Ink Tank. Be sure to press the mark on the Ink Tank to ensure it is firmly seated. Once the Ink Tank is installed, the printing job resumes. Printer error An error requiring servicing might have occurred (POWER lamp and Alarm lamp flash alternately). Disconnect the cable between the printer and the camera, turn off the printer, and unplug the power cord of the printer from the power supply. After a while, plug the power cord of the printer back in, turn on the printer, and then reconnect the camera to the printer. If the same error occurs, contact a Canon service representative. *1 To resume printing, you can press the OK button on the printer instead of selecting Continue. *2 The waste ink absorber absorbs ink used during cleaning, for example. If this message appears, you will need to call for servicing to replace the absorber and to check the printer for proper operation. 82