Canon EOS-1D X Mark III EOS-1DX Mark III Advanced User Guide - Page 726

67: Incorrect wireless LAN encryption method Are the camera and the access point set to use the same encryption method? • The camera supports the following encryption methods: WEP, TKIP, and AES ( ). If filtering by MAC address is active, is the MAC address of the camera in use registered at the access point? • Register the MAC address of the camera used to the access point. The MAC address can be checked on the [MAC address] screen ( ). 68: Cannot connect to wireless LAN terminal. Retry from the beginning. Did you hold down the access point's WPS (Wi-Fi Protected Setup) button for the specified period of time? • Hold down the WPS button for the period of time specified in the access point's instruction manual. Are you trying to establish a connection near the access point? • Try establishing the connection when both devices are within reach of each other. 69: Multiple wireless LAN terminals have been found. Cannot connect. Retry from the beginning. Connection is in progress by other access points in Pushbutton Connection mode (PBC mode) of WPS (Wi-Fi Protected Setup). • Wait a while before trying to establish the connection, or try to establish a connection in PIN code connection mode (PIN mode, ( )). 71: Cannot connect to receiver camera Are you following the correct procedure to establish the connection with receiver cameras? • Operate receiver cameras by following the correct instructions. Are the receiver cameras too far from the sender camera? • Bring the receiver cameras closer to the sender camera. 726