Canon LV-5220 Serial Functional Specification - Page 42

Expand Serial Command Functional Specification Page 41 of 41 9.12.4. CR_PTIMER Command Command "CR_PTIMER" [CR] Details Get Presentation Timer status. Acceptable "000_%a" [CR] "ON Presentation timer is active Response %a "STOP" ------- Presentation timer is pause "OFF" --------- Presentation timer is inactive Unacceptable "?" [CR] 9.12.5. CR_TEMPWARN Command Command "CR_TEMPWARN" [CR] Details Get if the sensors are exceeding or approaching critical temperature. When some sensors are installed inside the Projector, get each sensor's temperature. Acceptable "000_%a_%b_%c" [CR] % a : temperature sensor 1 status % b : temperature sensor 2 status % c : temperature sensor 3 status Response %a %b %c Unacceptable "W" ----- Exceeding critical temperature (Warning) "S" ------ Sensor temperature is safe "N" ------ Not relate to the temperature Ex.) When "S_W_S" [CR] means that sensor 1 is safety temperature, sensor 2 is exceeding critical temperature, and sensor 3 is safety temperature. Note) Depends on Projector models, when the temperature difference between sensor 1 and sensor 2 is over the specified temperature, the sensor may show "W". In this case, sensor 3 shows that the temperature difference is "W", "S", or "N". "?" [CR] 9.12.6. CR_TEMPFAIL Command Command "CR_TEMPFAIL" [CR] Details Get the temperature inside a Projector. When some temperature sensors are installed in the Projector, it is possible to know the temperature all at once. Acceptable "000_%a_%b_%c" [CR] % a : Temperature sensor 1 % b : Temperature sensor 2 % c : Temperature sensor 3 Response ％ａ ％b ％ｃ (Ex.) "_31.5F" [CR] _ means a space. When the temperature sinks to -, the first character "-" like "-05.5F" [CR]. Last character indicates the sensor's status. Exceeding critical temperature: "F" Sensor temperature is safe: "S" Not relate to the temperature: "N" Unacceptable "_31.5F" indicates 31.5 degrees and safety temperature. When the temperature is safe, the data will be "_00.0S". Every time the Projector is reset, "_00.0S" is set. In short, previous data is deleted. "?" [CR]