Canon MK 1500 Mk1500 Users Guide - Page 52
CANON FINETECH NISCA INC. shall not be responsible for damages
View all Canon MK 1500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Attaching the wrap-around tape 1. Peel the printed film from the wrap-around tape backing. When wrapping, the laminating cover should overlap the printed part sufficiently. We therefore recommend using with cable of φ3 to φ7.6 mm. 2. Attach the tape to the cable as shown in the diagram, starting from the printed end. 3. Wrap the transparent laminating portion so that it covers the printed part. If the film does not peel away from the backing Because wrap-around tape has a strong adhesive, it may be hard to peel the film off the backing. Refer to the following diagram for the peeling method. Peel-off Film Printable Area Hold the backing Peel the printed part away If the cut is too shallow Wrap-around tape is thicker than typical label tape, so the half-cut may be shallower. In this case, refer to "What To Do If the Cutter Is Getting Blunt" on page 96 to adjust cutting depth. If it still does not cut, replace with new cutter. ( page 98) If the half-cut is too shallow, the film may not peel from the backing properly. Printable Area If this part is joined, pull apart with your fingers If the remaining part cannot be separated, adjust the cutting depth. CANON FINETECH NISCA INC. shall not be responsible for damages that might result from the tape peeling off, or from fading of the printing on the tape. 48