Canon PIXMA MP560 Solución de problemas de configuración de red - Page 6

ENGLISH Problems during Software Installation WPS Settings The Machine is Not Displayed (Detected) Cannot connect. Multiple access points are enabled. is Displayed Check Action A A The message appears when multiple access points are detected. Wait for a while, then configure the settings again. Connection failed. is Displayed Check The message appears when an error occurs. Check the access point settings, then configure WPS settings again. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS (Wi-Fi Protected Setup)" on page 27 in the printed manual: Getting Started. • When using an access point that does not support WPS, configure settings manually. For the procedure to configure settings of the machine manually, refer to "Wireless Setup" on page 22 in the printed manual: Getting Started. Check 1 Make sure that you follow "Connection Checklist" on page 12, then click Update (A). Check 2 Is the machine connected to a network? • For details on how to check if the machine is connected to a network, refer to "Confirm Connection Status" on page 30 in the printed manual: Getting Started. If the machine is not connected to a network, perform setup again by following the procedures in "Wireless Setup" on page 22 and onward in the printed manual: Getting Started. Check 3 Is the IP filtering feature enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Set the access point to accept the IP address of the machine. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • To check the IP address of the machine, press the HOME button, then using the Easy-Scroll Wheel and OK button, select Settings > Device settings > LAN settings > Confirm LAN settings > Wireless LAN setting list, then check IP address.