Canon PIXMA MP560 Solución de problemas de configuración de red - Page 7

Check 4 When obtaining an IP address automatically, make sure that the DHCP function of the access point is active. • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Enable the DHCP function of the access point, then click Update (A). • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Check 5 Is the privacy separator feature enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Disable the privacy separator feature. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Glossary • IP address filtering A function to control traffic to/from specific IP addresses. • DHCP function A function that automatically assigns required information (IP address, etc.) to computers connected to the Internet. • Privacy separator feature A function to prevent communication between multiple wireless devices connected to an access point. Check Printer Settings dialog box is displayed Check The message appears when the machine cannot be detected. Check 1 Make sure that you follow "Connection Checklist" on page 12, then click Back (A). Proceed with the setup. A Check 2 Is the machine connected to a network? • For details on how to check if the machine is connected to a network, refer to "Confirm Connection Status" on page 30 in the printed manual: Getting Started. If the machine is not connected to a network, perform setup again by following the procedures in "Wireless Setup" on page 22 and onward in the printed manual: Getting Started. Check 3 Is the IP filtering feature enabled on the access point? • For details on how to check the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. Set the access point to accept the IP address of the machine. • For details on how to change the settings of the access point, refer to the manual supplied with the access point or contact its manufacturer. • To check the IP address of the machine, press the HOME button, then using the Easy-Scroll Wheel and OK button, select Settings > Device settings > LAN settings > Confirm LAN settings > Wireless LAN setting list, then check IP address.