Canon RP10 for CR-120/150 RP10 User Guide - Page 16

D Slightly pull the edge of paper, and then close the Paper Cover while pulling the paper forward so that the paper will not be loosened. The Status LED is lit green, and the printer is ready to print. IMPORTANT • Make sure to close the Paper Cover completely by pushing the protrusion in its center. If you push the edge of the Paper Cover, it becomes in a semi-locked state and may not be able to feed paper. • Load the paper so that when you close the Paper Cover, the paper is not pressed against the paper output section or askew. Otherwise, the paper may be fed at an angle and paper jams may occur. Paper pressed against output section Paper loaded askew E Press the Paper Cutter Button. If paper is cut properly, paper is loaded properly. Test Print A Press and hold the Power Button to turn OFF the power. B Press the Power Button while pressing the Feed Button to turn ON the power. The test print starts. The test print is performed repeatedly until you stop it. C Press the Feed Button to stop the test print. NOTE The test print stops if a printer error such as "Paper End" or "Paper Cover Open" etc. occurs. Once the error is cleared, the test print resumes. a. 50% checkered pattern printed (2 lines) b. 25% checkered pattern printed (3 lines) c. Status of the internal settings printed The statuses of the interface settings and other advanced settings are printed. d. Japanese character set (12 x 24) (a complete set) e. Standard character set (12 x 24) (a complete set) f. International character set (12 x 24) (a complete set) g. Japanese character set (08 x 16) (a complete set) h. Standard character set (08 x 16) (a complete set) i. International character set (08 x 16) (14 lines) j. Kanji (24 x 24) (15 lines) k. 100-dot feed, partially cut l. 160-dot feed, fully cut 16