Canon VB-S31D Mark II Network Camera Operation Guide - Page 160
[Server] > [RTP Server] RTP Settings, RTP Server, Audio Multicast
View all Canon VB-S31D Mark II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 160 highlights
[Server] > [RTP Server] RTP Settings Set the video and audio transmission using RTP. The following settings can be configured here. • RTP Server • Audio Multicast • RTP Stream 1 to 5 RTP Server Enable RTP, and set the RTSP authentication method and port number. [RTP] Select this to enable or disable RTP. [RTSP Authentication Method] Select an authentication method for RTSP. Since the RTSP authentication method is configured independently of the HTTP authentication method, you need to configure each authentication method. [RTSP Port] Enter the RTSP port number. Normally use [554] (factory default setting). Audio Multicast Set multicast for audio transmission. [Multicast Address] Enter the multicast address for audio transmission as follows. IPv4: Range from 224.0.0.0 to 239.255.255.255. IPv6: Address starting with ff00::/8 Set IPv4 to [0.0.0.0] and IPv6 to [::0 (::)] to disable multicast. [Multicast Port] Enter the multicast port number for audio transmission. If set to [0], multicast is disabled. [Multicast TTL] Enter the effective range for multicast transmission. If set to [0], multicast is disabled. The TTL (Time To Live), representing the effective range for multicast transmission, is decremented each time the signal passes through a router. When the value reaches 0, the signal can no longer pass through the router and be transmitted. For example, if TTL is set to [1], multicast transmission is confined to the local segment only and cannot pass through the router to be transmitted. 142