Canon iPF810 iPF810 User Manual - Page 683

Messages regarding paper Rel lever is in wrong position. Cause The Release Lever is up. Corrective Action Lower the Release Lever. If the error occurs again, turn off the printer and wait a while before restoring power. Rewinding error. Cause Corrective Action There is some foreign object near the Media Take-up Remove the foreign object near the sensor. Unit sensor and the roll cannot be detected. The Media Take-up Unit sensor is soiled and the roll Wipe the sensor with a dry cloth to clean it. cannot be detected. The roll is out of range of detection by the Media Take-up Unit sensor. Reload the roll. (→P.139) The Media Take-up Unit sensor is damaged. Contact your Canon dealer for assistance. A paper jam has occurred and the roll cannot be rewound. Remove the paper from the Media Take-up Unit. Press the Online button to clear the error. *Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip Take-Up Err to On. Media take-up unit ready. Cause Corrective Action The Take-up Reel setting in the printer MAIN MENU was changed from Enable to Disable, but a print job was received before the roll was removed. Press the Stop button and stop printing. The mode switches from take-up mode to regular mode after you change the Take-up Reel setting in the MAIN MENU from Enable to Disable and lift the Release Lever, or after you execute Paper Cutting. Press the Online button to resume printing. Turn on the media take-up unit. Cause The Media Take-up Unit was off when you selected Enable for Take-up Reel. Corrective Action Turn the Media Take-up Unit on. Error Message 669