Canon iPF810 iPF810 User Manual - Page 689

Messages regarding printing or adjusment Cannot adjust printhead. Cause The Printhead nozzles are clogged. Corrective Action Execute Auto Head Adj. again, as follows. 1.Press the Online button to clear the error. 2.Print a test pattern to check the nozzles. (→P.587) 3.Clean the Printhead if the nozzles are clogged. (→P.588) 4.Execute Auto Head Adj. again. (→P.554) The Printhead cannot be aligned; highly transparent lm is loaded. Press the Online button to clear the error. We recommend using a type of paper that you often use, other than lm, for Printhead adjustment. (→P.554) The Printhead is installed crooked. Straighten the Printhead as follows, and then execute Auto Head Adj. again. 1.Press the Online button to clear the error. 2.Use Head Inc. Adj. to adjust the angle of inclination of the Printhead. (→P.558) 3.Execute Auto Head Adj. again. (→P.554) Borderless printng not possible. Paper stretched or shrank. Cause Corrective Action The loaded roll has expanded or contracted due to Hold down the Stop button for a second or more to environmental conditions, making it wider or narrower cancel printing. than the supported width for borderless printing. Use each type of paper only where the recommended environmental conditions are met. For details on environmental conditions for various paper, see the Paper Reference Guide. (→P.125) Before borderless printing, move the blue platen switch. Cause Corrective Action The blue Switch on the platen was set to the side Before borderless printing, set the blue Switch on the opposite ● when a borderless print job was received. platen to the ● side. (→P.639) Error Message 675