Casio CTK7000 User Guide - Page 78
Re-recording Part of a Song, Punch-in Recording
View all Casio CTK7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Using the Song Sequencer Mixer Settings in the Song Sequencer Mode You can access the mixer during playback, playback standby, or record standby (C-6 (RECORD) button flashing), or while recording is in progress (C-6 (RECORD) button lit). Press the C-7 (MIXER) button to display the mixer screen. To return to the song sequencer mode screen, press the C-7 (MIXER) button again or press the R-15 (EXIT) button. The table below shows how mixer parts correspond to song sequencer parts. Mixer Song Sequencer Parts A04 to A07, A09 to A16 System Track Parts B01 to B16 Tracks 01 through 16 Supported Mixer Operations during Playback or Playback Standby All mixer settings can be configured during playback or playback standby, subject to the following precautions. • If you want to change mixer settings during playback standby, change them after selecting the song you want to play back. If you change mixer settings and then change the song selection, the header settings of the newly selected song will be recalled and mixer settings will be changed accordingly. • The only mixer settings you can change during playback standby are those that are included in the song header of the currently selected song. If mixer settings were changed part way through when recording the song, the later recorded mixer settings will supersede any settings you make during playback standby. Supported Mixer Operations during Record Standby The mixer settings for the parts shown below (excluding part on/off) are supported, depending on the track being recorded to. Settings are recorded to the header settings (page E-71), the same way settings are stored when recording is started. System Track Tracks 01 through 16 A05 (UPPER 1), A06 (UPPER 2), Parts corresponding to A07 (LOWER), A04 (Auto each track harmonize) parts (B01 through B16) Supported Mixer Operations During Recording Mixer settings cannot be configured during recording to the system track. Configuration of mixer settings (except for part on/off) is supported for a part (B01 through B16) that corresponds to a track when recording to any track from 01 through 16 shown. Any change in a mixer setting on the mixer screen is recorded as soon as it is made. For details about mixer functions and operations, see "Using the Mixer" (page E-36). Re-recording Part of a Song (Punch-in Recording) You can re-record parts of a song you previously recorded in order to correct errors, etc. Simply enter the record standby mode and play back the previously recorded song (punch-in playback) and then play the new notes when playback reaches the location of the part you want to change. Mistake Playback Use punch-in recording to re-record only this part. To start re-recording from a particular location during playback (Manual Punch-in) 1. Press the C-5 (SONG SEQUENCER) button to enter the song sequencer mode. 2. Use the dial or the R-14 (-, +) buttons to select a song area number. 3. Press the C-6 (RECORD) button to enter record standby. • This causes the button to start flashing. 4. Use the R-17 (u, i) buttons to select the track you want to partially re-record. 5. Hold down the C-6 (RECORD) button until the punch-in/punch-out screen shown below appears. E-76