Casio KL-820 User Guide - Page 10

To load the batteries Caution • Do not touch the springs inside the battery compartment cover with your fingers while loading or replacing batteries. The springs have sharp areas and can cut your fingers. Important! • The Label Printer can run on six AA-size alkaline batteries. Be sure to use alkaline batteries only. 1. Turn power off. • If you are using the optional AC adaptor for power, you should also unplug it from the Label Printer. 2. Turn over the Label Printer. Open the battery compartment cover as shown in the illustration. 3. Load batteries into the battery compartment. • Be sure to use alkaline batteries. • Make sure the positive (+) and negative (-) ends of the batteries are facing in the correct directions. AC Adaptor Note the following important precautions when using an optional AC adaptor to power your Label Printer. • Use only a genuine CASIO AD-A95100 AC adaptor with the same voltage rating as the household current in your area. Using a wrong adaptor can damage your Label Printer. • Be sure to turn the Label Printer off before you connect the adaptor. Do not turn power on until the adaptor is connected to the Label Printer and plugged into and AC outlet. • Be sure to unplug the AC adaptor from the AC outlet whenever you are not using the Label Printer. To connect the AC adaptor Connect the adaptor to the Label Printer as shown in the illustration. Plug the other end into a standard household AC outlet. • Take care that you do not excessively bend or twist, or pull on either end of the AC adaptor. Turning Power On and Off Press ON/OFF to turn power on and off. Power On a b 0. 0 cm 4 ×4 Power Off 4. Replace the battery compartment cover. Important! • If you are using the Label Printer for the first time, you should reset it first. E-9