Casio PCR T265 Owners Manual - Page 10

Part-1 QUICK START OPERATION 3. Loading paper roll Mode switch to REG CAL RREEGG X Options: Roll paper ••• P-5880T 6 Remove the printer cover by lifting up 5 Remove the journal paper from the the back. take-up reel. printer cover OFF Z RF PGM 1. To load journal paper 1 Pressing down the printer open key. 7 Roll the paper onto the take-up reel a few turns. 8 Set the left plate of the take-up reel and place the reel into the register. 6 Press the printer open key and open the platen arm. 2 Open the platen arm. 7 Remove the core of the paper. platen arm 9 Press the l key to take up any slack in the paper. 0 Replace the printer cover slowly. 3 Ensuring the paper is being fed from the bottom of the roll, lower the roll into the space behind the printer. 4 Put the leading end of the paper over the printer. 5 Close the platen arm slowly until it locks steadily. 2. To remove journal paper 1 Remove the printer cover by lifting up the back. 2 Press the lkey until approximately 20cm of the paper is fed from the printer. 3 Cut off the roll paper. 4 Remove the take-up reel from the printer and take off the left plate of the reel. 8 Load new paper following the instruc- tions "1. To load journal paper". Default printer definition is journal printer. To print receipts, please refer to the "Basic programming for QUICK START" on the next page. ◗ To load receipt paper 1 In case of defining the printer as receipt printer, follow steps 1 through 5 of "To load journal paper". 2 Pass the leading end of the receipt paper through the paper outlet of the printer cover. 3 Tear off any excess paper. ◗ To remove receipt paper 1 In case of defining the printer as journal printer, follow steps 6 through 7 of "To remove a journal paper". ◗ Caution (in handling the thermal paper) 1. Never touch the printer head and platen. 2. Unpack the paper just before your use. 3. Avoid heat/direct sunlight. 4. Avoid dusty and humid places for storage. 5. Do not scratch the paper. 6. Do not keep the paper under the following circumstances: High humidity and temperature/direct sunlight/contact with glue, thinner or a rubber eraser. E 10