Chamberlain RJO20 RJO20 Owner s Manual - English - Page 11
continued
![]() |
View all Chamberlain RJO20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Installation (continued) 5. Remove the garage door opener from torsion bar. 6. Drill 3/16 inch pilot holes at the marked locations. Drill through metal door rail plates if necessary. 7. Slide the garage door opener back onto the torsion bar until pilot holes align with bracket. 8. Tighten the 2 square head set screws on the torsion bar. For a hollow torsion bar, tighten screws 3/4 - 1 full turn after making contact with the bar. For a solid shaft torsion bar, tighten screws 1/4 - no more than 1/2 turn after making contact with the shaft. If installing on a keyed torsion bar, DO NOT tighten the screws into the keyway. 9. Secure the mounting bracket to the wall and to the garage door opener. Use the 14‑10x2" screws to secure the mounting bracket to the wall. Set screws (Torsion bar) Screws 14-10x2" Mounting Bracket NOTE: Due to torsion bars being out-of-round, the operator may wobble during operation. This is normal. 11
![](/manual_guide/products/chamberlain-rjo20-rjo20-owner-s-manual-english-57a070d/11.png)