Chamberlain RJO20 RJO20 Owner s Manual - English - Page 29

Programming Your hand-held remote control (model 953ESTD) has already programmed to the door control (myQ® Control Panel) at the factory. Below are instructions for programming additional remote controls, keypads, and myQ® enabled accessories to the door control. NOTE: Use the learn button on the door control to program all accessories. The yellow learn button on the garage door opener will NOT program accessories. To Add a Remote Control, Keypad, or myQ® Enabled Accessories REMOTE CONTROL 1. Press the myQ® Control Panel LEARN button twice, the red learn LED will turn on. 2. Press the button on the remote control that you wish to operate your garage door. 3. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. KEYPAD 1. Press the myQ® Control Panel LEARN button twice, the red learn LED will turn on. 2. Enter a 4-digit personal identification number (PIN) of your choice on the keypad. Then press the ENTER button. 3. The garage door opener lights will flash (or two clicks will be heard) when the code has been programmed. Command LED (yellow) Learn LED (Red) ? ?? ? PIN myQ® ENABLED ACCESSORIES 1. Press the myQ® Control Panel LEARN button twice, the red learn LED will turn on. 2. Press the LEARN button on the myQ® device.* LEARN Button LEARN Button Model PILCEV - Remote Light Control Light module can be synchronized with the garage door opener light bulbs. Model 041A7614 - Garage Door Monitor Indicates the status of your garage door from inside the home and allows you to close an open garage door from inside the house. LEARN Button Model WSLCEV - Remote Light Switch Light module can be synchronized with the garage door opener light bulbs. *myQ® accessories may be programmed to the Chamberlain® Internet Gateway (Model 828LG) or the myQ® Control Panel. 29